top of page
Galvanised slope base flange

Slope Base Flange (251)

251 (B C D) 

 

Slope Base Flange, also called angle base flange, is used to set up the upright at an angle between 30° – 45°.

 

This fitting should only be subjected to light loads which cannot be positioned at 90° to the applied load. Where greater load is required, clamp fitting #132 is normally used with the upright tube bent to the required angle. 

 

We also supply Galvanised tubes. To buy our 3.2m galvanised tube, click here. To buy our 6m galvanised tube, click here.

 

Please click here to view our full range of galvanised tube clamps.

 

B: Size to fit 33.7mm O.D. tube
C: Size to fit 42.4mm O.D. tube
D: Size to fit 48.3mm O.D. tube

  • If you are unsure about a certain specification or would like to enquire further please contact us on the below:

    T: 0131 333 4413

    E: sales@kitegroupltd.com

PriceFrom £15.01
VAT Included
Quantity

Related Products

bottom of page